Fan Assembly

Description

Spare part number

 

 

Fan

656834-001

 

 

The fan assembly is attached to the inside floor of the chassis using two screws. The fan is inside of a removal metal cage.

1.Prepare the computer for disassembly (Preparation for Disassembly on page 104).

2.Remove the access panel (Access Panel on page 105).

3.Remove the front bezel (Front Bezel on page 107).

4.Disconnect the fan cable from the system board connector labeled SYS_FAN.

5.Remove the Torx screw that secures the left side of the fan to the computer.

6.Cut the plastic tie (1) that secures the fan cable to the power supply power cables.

7.Remove the two screws (2) that secure the fan to the computer. The screw near the computer side is not shown in the following image.

8.Lift the fan assembly up and out of the computer (3).

132 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis