INSTALLATION

2.7.1 GENERAL

The optional data pigtail cable is supported by Multi-Net versions only. It is installed when a modem or some other type of data device is to be connected to the transceiver. This cable connects the data equipment to data connector J301 on the audio/logic board. Two data cables are available (see Table 1-3), and descriptions of each follow.

Data/Accessory Pigtail Cable, Part No. 597-9800-001

This cable is a combination data and accessory pigtail cable. It does not include a connector for interfacing with the data equipment. The wires are unterminated and connected to a user-supplied connector as desired. The cable has 15 conductors. All 13 pins of J301 are brought out, and there are two additional wires that can be connected inside the transceiver as desired.

Data Pigtail Cable, Part No. 597-9800-005

This is a data cable only (it does not include the accessory cable). The data cable is similar to the one included with the -001 cable. It has 15 unterminated wires, and a user supplied connector is installed as desired.

2.7.2 DATA CABLE INSTALLATION

1.Remove the bottom cover of the transceiver to access the audio/logic board.

2.Refer to Figure 2-6and plug the 13-pin connector of the data cable into J301. If also installing the acces- sory cable, plug the 7-pin connector into J701. Refer to Section 2.4 for more accessory cable installation information.

3.Refer to the wiring chart in Table 2-1and connect the data cable wires to the user supplied connector as required for the data equipment being used.

4.If required, install the purple and pink wires to the desired points in the transceiver.

5.Position the strain relief grommet of the accessory/ data cable in the external speaker jack slot of the chassis as shown in Figure 2-6and reinstall the bottom cover. bottom cover.

Table 2-1 Data Cable Wire Chart
J301 Pin No.

Function

Wire Color

 

 

 

1

Sw Bat Out

White

2

Rx Filt Out

Green

3

Tx Filt In

Yellow

4

TxD

Blue

5

RxD

Orange

6

Transmit

Gray

7

IN2

Brown

8

Ext Serv Req

White/Red

9

Option 1

White/Green

10

Output C

White/Black

11

Ext Pwr Sw

White/Blue

12

8V Out

Red

13

Ground

Black

NC

User Defined

Purple

NC

User Defined

Pink

2.8 KEY CAP KITS

NOTE: To remove a key cap, insert a tool with a sharp tip in the slot on the bottom of the cap and carefully pry against the front panel to release the cap.

2.8.1 MULTI-NET AND LTR-NET MODELS

Key Cap Kit, Part No. 587-9840-001, is standard with each Multi-Net transceiver and includes the five caps indicated below.

FCN

SCAN

A/D

TA

AUX

Key Cap Kit, Part No. 587-9840-002, is standard with each LTR-Net transceiver and includes the five caps indicated by an asterisk (*) in the list which follows.

An optional key cap kit, Part No. 587-9840-004, is also available which includes all of the caps in the following list:

FCN*

SCAN*

A/D*

ROAM*

TEL*

TA

AUX

HOME

PAGE

HORN

C/G

PRI

USR1

USR2

MON

CPND

MHNG

STLH

MICPA

BANK

EMER

ENCPT

Rx PA

CALL

 

(Blank)

(Blank)

 

 

 

 

February 2001

2-8

Part No. 001-9800-001