
GENERAL INFORMATION
SECTION 1 GENERAL INFORMATION
1.1.1 GENERAL
This service manual contains installation and service information for all current 9800 series mobile transceivers. These include the UHF 984x, 800 MHz 988x, and 900 MHz 989x models.
This manual does not include operation, program- ming, or alignment information. This information is covered by a separate operation/programming manual (addendum) for each operating protocol as follows:
Protocol | Operation and Programming | |
|
| Manual |
98xx |
| |
98xx |
| |
98xx SMARTNET™/ | ||
SmartZone® |
|
|
Therefore, use this manual to install and service 98xx transceivers, and use the above manual for oper- ation, programming, and tuning information.
NOTE: The above
1.1.2 LTR® , LOW TIER, AND DATA MODELS
NOTE: LTR, low tier, and data versions of the 98xx transceiver are no longer available.
The LTR versions of the 98xx are covered by LTR 98xx Service Manual, Part No.
The LTR models of the 98xx mobile were available in both high and low tier versions, and the Multi- Net,
The data version of the 98xx transceiver has a front panel that is blank except for the programming jack. For servicing information on data models, refer to the LTR manual just described.
The
NOTE: External data equipment is currently not supported by the
1.2.1 GENERAL
The
1.2.2 AVAILABLE FREQUENCY BANDS
UHF Models
•
•All currently available models are dual bandwidth (12.5/25 kHz). Therefore, they can be programmed to operate on both types of channels.
•High power (40W) or medium power (25W) models available.
800 MHz Models
•Full band
•All currently available models are dual bandwidth (12.5/25 kHz).
•High power (30W) and medium power (15W) models available.
| February 2001 |
Part No. |