Introduction
Preparing to Install the CD±ROM Drive
The following information is provided to prepare the CD±ROM for installation.
Tools Required
The following tools are needed to install the CD±ROM drive:
•#2 Phillips screwdriver
•Small needle±nose pliers
Verifying Kit Contents
Verify that the kit contains one of each of the following:
•CD±ROM drive (drive P/N A4325±60001)
•Set of 4 screws (M4x6)
•Power adapter cable
•SCSI I/O cable
•Static strap
•HP 4x Speed CD±ROM Disk Drive User's Guide (A1658±90669)
NOTICE: If any contents of your kit are missing, contact your sales representative.
Minimum Requirements
Minimum requirement for the HP±UX operating system is level 9.03 for the HP 4x Speed CD±ROM drive.
NOTICE: You must use software patch PHSS_5764 under HP±UX 9.03, 9.05 and 9.07 to run SupportWave successfully.
1±6
