Optical drive
Description | Spare part number |
|
|
Optical drives |
|
|
|
|
|
DVD±RW and | |
|
|
Before removing the optical drive, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 46).
5.Remove the memory module compartment cover (see Expansion memory module on page 50). Remove the optical drive:
1.Position the computer with the right side toward you.
2.Remove the Mylar screw cover (1) that secures the optical drive retention screw. The Mylar screw cover is available in the Rubber Kit, spare part number
3.Remove the two Torx T8M2.0×5.0 screws (2) that secure the optical drive to the computer.
4.Remove the optical drive (3) from the computer.
5.If it is necessary to replace the optical drive bracket, position the optical drive with the rear toward you.
6.Remove the two Phillips PM2.0×4.0 screws (1) that secure the optical drive bracket to the optical drive.
60 Chapter 4 Removal and replacement procedures
