
QuickSpecs
HP ProLiant DL160 Generation 5
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for additional information.
NOTE: HP does not allow factory integration of options into standard models listed above.
NOTE: This product offering does not support HP Factory Express Server Configuration Level 1.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Configuration (choose one of the following configurable models)
Non-Hot Plug SATA Model
NOTE:
HP ProLiant DL160 G5 |
Factory Integrated Model ships with:
Two embedded NC105i PCIe Gigabit Server Adapters (WOL &
Two available
Slot 1:
Slot 2:
650 Watt Power Supply
One Highline IEC Power Cord
6
Rack (1U), (1.75 in / 4.45 cm)
Fixed Rails
Hot Plug Model
HP ProLiant DL160 G5 Hot Plug SAS/SATA Rack CTO Chassis |
Factory Integrated Model ships with:
Two embedded NC105i PCIe Gigabit Server Adapters (WOL &
Two available
Slot 1:
Slot 2:
650 Watt Power Supply
One Highline IEC Power Cord
6
Rack (1U), (1.75 in / 4.45 cm)
Fixed Rails
Step 2: Choose Required Options (only one of the following from each list unless otherwise noted)
Processors |
| |
|
FIO
NOTE: If 2 processors are desired, select one
B21.
DA - 12902 Worldwide QuickSpecs — Version 19 — 1/26/2009 | Page 15 |