HP DL160 manual Storage Controller, Storage Optical Drives, Drive Bays, Maximum Internal

QuickSpecs

HP ProLiant DL160 Generation 5

Standard Features

Network Controller Two embedded NC105i PCIe Gigabit Server Adapters

Expansion Slots #	Technology	Bus Width	Connector	Bus	Device No.** Form Factor		Notes
			Width*	Number*
1	PCI-Express	x16	x16	1	0	Full length,	3.3 volts
	2.0					full height
1	PCI-X***	64-bit	N/A	5	1	Full length,	3.3 volts
						full height
2	PCI-Express	x16	x16	6	3	Low Profile	3.3 volts
	2.0
2	PCI-X***	64-bit	N/A	5	1	Low Profile	3.3 volts

NOTE: All slots can accept universal keyed PCI cards

*Default bus assignment. Inserting cards with PCI bridges may alter the actual bus assignment number.

**Slots are enumerated differently based on OS. MS OS's enumerate from lowest to highest Device ID by bus (starting with the lowest bus).

***PCI-X bus speed will be 133MHz when only one PCI-X card is installed. It will be 100MHz when both slots have PCI-X cards installed.

Storage Controller	Non-Hot Plug SATA	HP Embedded SATA RAID Controller (integrated into the south-bridge)
	Models	supporting SW RAID 0,1
		NOTE: Transfer rate: 1.5 Gb/s SATA
	Hot Plug SATA/SAS	HP SC40Ge HBA with RAID 0, 1
	Models	NOTE: When using the SC40Ge with SATA Hard Drives, 1.5G SATA
		Hard Drives are required.
		NOTE: Transfer rate: 1.5 Gb/s SATA, 3 Gb/s SAS
	NOTE: A diskette drive, USB floppy drive key or virtual FDD using LO100 Advanced Pack is
	needed to install storage controller drivers during a Windows operating system installation from a
	CD.
Storage	Optical Drives:
	DVD-ROM	8x IDE (ATAPI) DVD-ROM drive, slim (optional)
	DVD/CD RW	24x IDE (ATAPI) CD-ROM drive (optional)
	Diskette Drives	Via USB only
	Drive Bays:
	Non-Hot Plug SATA	Up to 4 Non-hot plug SATA 3.5" drives
	Hot Plug SATA/SAS	Up to 4 Hot plug SAS/SATA 3.5" drives
Maximum Internal	Non-Hot Plug SATA	3.0TB	4 x 750GB
Storage	Hot Plug SATA	4.0TB	4 x 1TB
	Hot Plug SAS	4.0TB	4 x 1TB

DA - 12902 Worldwide QuickSpecs — Version 19 — 1/26/2009 Page 5