HP DL160 manual Server Power Cords, UPS and PDU Power, Cord Matrix, Power Supply, System Fans

QuickSpecs

HP ProLiant DL160 Generation 5

Standard Features

Server Power Cords	One 6' Highline (IEC-IEC) power cord ships standard
	NOTE: HP ProLiant DL servers no longer ship standard with NEMA power cords (163719-002)
	that allow connection to 110V US wall outlets in a home or office. ProLiant DL servers are
	primarily connected to PDU's in data center racks so they now ship standard with only a PDU
	power cord (416151-B21). If a user wishes to power a ProLiant DL server using a 110V receptacle
	(NEMA-15), the NEMA power cord (227099-001) must be ordered separately.
	If customers require a local power cord, they can check the power cord matrix for the appropriate
	cord. Please see the following power cord matrix: http://www.hp.com/go/powercordmatrix.
UPS and PDU Power	Please see the UPS and PDU cable matrix that lists cable descriptions, requirements, and
Cord Matrix	specifications for UPS and PDU units:
	http://h18004.www1.hp.com/products/servers/proliantstorage/power-protection/index.html.
Power Supply	650 Watts, auto-switching, PFC (Power Factor Correcting)
	NOTE: Factory upgradeable to high-efficiency (HE) power supply for lower TCO
System Fans	6 system fans ship standard; Non-hot plug, Non-redundant
OS Support	Microsoft Windows Server 2003 R2
	Microsoft Windows Server 2008
	Microsoft Windows Small Business Server 2008
	Microsoft Windows Essential Server 2008
	Red Hat Enterprise Linux
	SUSE Linux Enterprise Server
	Sun Solaris for x64/x86-based Systems
	NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and
	Virtualization Software and latest listing of software drivers available for your server, please visit
	our Support Matrix at: http://www.hp.com/go/supportos and our driver download page
	http://www.hp.com/support/DL160G5.
Rack Airflow	Rack 10000 series Cabinets
Requirements	The increasing power of new high-performance processor technology requires increased cooling
	efficiency for rack-mounted servers. The 10000 Series Racks provide enhanced airflow for
	maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
	CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
	adequate airflow and to prevent damage to the equipment:
	Front and rear doors: If your 42U server rack includes closing front and rear doors, you must allow
	5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to permit adequate
	airflow (equivalent to the required 64 percent open area for ventilation).
	Side: The clearance between the installed rack component and the side panels of the rack must
	be a minimum of 7 cm (2.75 inches)
	CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
	This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
	cooling that can lead to thermal damage.

DA - 12902 Worldwide QuickSpecs — Version 19 — 1/26/2009 Page 9