Muratec F-116 Operation Not, Assigned, Paper Jam, Open/Close Door, Check Inside, Power Failure

MESSAGE	MEANING	SUGGESTED SOLUTIONS
Operation Not	You are doing in the Add/Cancel operation,	Check the display to see if there is any
Assigned	but there is no jobs waiting.	scheduled job. The display should indicate
		them in standby mode, for example, Delay
		Fax.
[Paper Jam 0]	Paper has jammed in the feeding area of the	Clear the jam (See "In tray 1" on page56).
Open/Close Door	paper tray.
[Paper Jam 1]	Paper has jammed in the paper exit area.	Clear the jam (See "Inside the machine" on
Open/Close Door		page57).
[Paper Jam 2]	Paper has jammed in the fuser area.	Clear the jam (See "In exit area" on
Check Inside		page57).
Power Failure	Power has turned off then on and the	You need to start again the job which you
	machine’s memory has not been saved.	were trying to do before the power failure.
Replace Toner	The toner cartridge has almost reached its	You can choose between Stop or Continue
	estimated cartridge life.	as shown on the control panel. If you select
		Stop, the printer stops printing and you
		cannot print any more without changing the
		cartridge. If you select Continue, the printer
		keeps printing but the printing quality cannot
		be guaranteed.Replace the toner cartridge
		for the best print quality when this message
		appears. Using a cartridge beyond this
		stage can result in printing quality issues
		(See "Replacing the toner cartridge" on
		page68).
		Muratec does not recommend using
		non-genuine Muratec toner cartridges
		such as refilled or remanufactured.
		Muratec cannot guarantee
		non-genuine Muratec toner
		cartridge's quality. Service or repair
		required as a result of using
		non-genuine Muratec toner
		cartridges will not be covered under
		the machine warranty.
Retry Redial?	The machine is waiting for a specified time	You can press OK to immediately redial, or
	interval to redial a previously busy station.	Stop/Clear to cancel the redial operation.
[Stop Pressed]	The Stop/Clear button is pressed during a	Try again.
	copy or fax operation.
End of life	The indicated toner cartridge has reached its	Replace the toner cartridge (See "Replacing
Replace new cart	estimated cartridge life. The printer stops	the toner cartridge" on page68).
	printing.
	Estimated cartridge life means the
	expected or estimated toner cartridge
	life, which indicates the average
	capacity of print-outs and is designed
	pursuant to ISO/IEC 19798 (See
	"Available supplies" on page67).
	The number of pages may be affected
	by operating environment, printing
	interval, media type, and media size.
	Some amount of toner may remain in
	the cartridge even when End of life
	Replace new cart appears and the
	printer stops printing.
Prepare new cartridge	Small amount of toner is left in the cartridge.	Prepare a new cartridge for replacement.
	The estimated cartridge life of toner is close.	You may temporarily increase the printing
		quality by redistributing the toner (See
		"Redistributing toner" on page53).

Troubleshooting_ 60