HP DV6 manual Webcam/microphone module, on page

Webcam/microphone module

NOTE: This section applies only to computer models equipped with BrightView display assemblies. See Display assembly on page 75 for webcam/microphone module removal instructions for computer models equipped with AntiGlare display assemblies.

NOTE: If it has been determined that the webcam/microphone module is the component that must be replaced to complete the computer repair, the display assembly does not have to be removed. Follow the procedures in this section to replace the webcam/microphone module. For information on replacing the display assembly and other display assembly internal components, see Display assembly

on page 75.

Description	Spare part number
Webcam/microphone module for use only with computer models equipped with BrightView display	512827-001
assemblies (includes double-sided tape)

Before removing the webcam/microphone module, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 54).

Remove the webcam/microphone module:

1.Turn the computer display-side up, with the front toward you.

2.Open the computer as far as possible.

3.Flex the inside edges of the top edge (1) and the left and right upper corners (2) of the display bezel until the bezel disengages from the display enclosure.

Component replacement procedures 55