|
|
| Getting Started | |
|
| |||
|
| |||
Diagnostic Front Panel LEDs and Audible Codes | ||||
|
|
|
| |
|
| Possible | Recommended |
|
Activity | Beeps | Cause | Action | |
|
|
|
|
|
Red Power LED | 9 | System powers on | 1. Check that the | |
flashes nine |
| but is unable to | voltage selector, | |
times, once every |
| boot. | located on the rear of | |
second, followed |
|
| the power supply | |
by a two second |
|
| (some models), is set | |
pause. The beeps |
|
| to the appropriate | |
continue for five |
|
| voltage. Proper | |
iterations, then |
|
| voltage setting | |
stop. The LED |
|
| depends on your | |
flashes continue |
|
| region. | |
until the problem |
|
| 2. Replace the system | |
is resolved. |
|
| ||
|
| board. | ||
|
|
| ||
✎ Beeps may |
|
| 3. Replace the | |
not occur |
|
| processor. | |
on all |
|
|
|
|
models for |
|
|
|
|
this activity. |
|
|
|
|
|
|
|
|
|
Red Power LED | 10 | Bad option card. | 1. Check each graphics | |
flashes ten times, |
|
| card by removing the | |
once every |
|
| card (one at a time if | |
second, followed |
|
| multiple cards), then | |
by a two second |
|
| power on the system | |
pause. The beeps |
|
| to see if fault goes | |
continue for five |
|
| away. | |
iterations, then |
|
| 2. Once a bad card is | |
stop. The LED | identified, remove | |
flashes continue | ||
and replace the bad | ||
until the problem | ||
option card. | ||
is resolved. | ||
3. Replace the system | ||
| ||
| board. | |
|
|
Getting Started | www.hp.com | 29 |
