changing the receiver name

During setup, the receiver name defaults to “My Receiver”. You can either leave this name or change it to something more meaningful, such as “Living Room” or “Bedroom”. The name is used when allowing access to your servers, or when you are controlling more than one media receiver on your network.

From the home screen, press the options button, select Preferences and then Receiver Name. Use the onscreen keyboard to edit the name.

controlling another receiver

You can control music playback on another receiver if you have more than one media receiver on your network. See “controlling music playback” on

page 28.

screen saver

The screen saver will appear after two minutes of inactivity. Press any button on the remote to exit the screen saver.

The screen saver time-out can be changed. From the home screen, press the options button, select Preferences and then Screen Saver Delay. Choose a delay from a minimum of15 seconds to a maximum of 10 minutes.

Note: If your TV is sensitive to screen burn-in, you should reduce the screen saver delay to a minimum. Consult your TV manual for recommended settings.

running the setup wizard

The setup wizard runs the very first time you setup your hp digital media receiver. If you relocate the receiver or wish to make changes to your settings, you can run the setup wizard again.

From the home screen, press the options button, then highlight and select Run Setup Wizard.

12hp digital media receiver