If DHCP is not enabled, you will need to assign a static address to your media receiver. Take note of the IP Address and Subnet Mask listed by the ipconfig utility, and see “wired with static address” on

page 38.

Note: If you cannot tell how your network addresses are assigned, then try dynamic address (DHCP) first. The media receiver will display an error message if it is unable to dynamically configure its address.

wired home network

hub or router

TV

In a wired home network, all computers are connected to a network hub or router. This may also act as a cable/DSL modem for sharing an internet connection.

wired with dynamic address

Connect the media receiver to your router, just as you would one of your computers. In almost all cases, the router works as a DHCP server (i.e., it assigns network addresses).

Set the media receiver network settings to wired using DHCP addressing. From the main home screen:

1.Press options2.Select Network Setup3.Set Connection to Wired (Ethernet)

4.Select Address

5.Set Configuration to DHCP

6.Press left arrow to return to receiver options

7.Select Apply Changes to apply the network changes

user’s guide 37