1 Connecting to a Netware 3.12 Server
Windows 95 SR2
Windows 95 SR2 | Requirements | |
| • HP Vectra with Windows 95 SR2 installed. | |
| • Intel EtherExpress Pro 10+ ISA Ethernet card and drivers disk. | |
| • | Driver Name for Vectra VL8 and VE7/VE8: NETPRO.INF Size: 12KB |
|
| Date: 4/25/97. |
| • | Driver Name for Vectra VL7: EPRO.SYS Size: 11KB Date: 6/3/97. |
• Novell Netware 3.12 server that supports Net BEUI,TCP/IP, NWLink IPX/ SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
|
|
| Vectra VL8 | Vectra VL7 |
| Vectra VE7/VE8 |
|
|
|
|
|
|
|
| I/O Address |
|
| |||
|
|
|
|
|
|
|
| Interrupt |
| 10 | 10 |
| 11 |
|
|
|
|
|
| |
• | Board Connector type |
| ||||
• | Force | operation |
| Yes | ||
• | Flash chip address |
| Disabled | |||
• | Remote boot program |
| None | |||
Procedure
1With the HP Vectra turned off, install the Intel EtherExpress Pro10+ ISA adapter card into an ISA slot.
2Connect network Cable media to the Intel EtherExpress ISA card.
3Insert a DOS bootable diskette and power on the machine.
4After booting, insert the Intel EtherExpress drivers disk, “EtherExpress drivers Ver. 3.5” and execute “A:\SOFTSET2.EXE.”
5Select “Configure NIC”, and verify the resource settings listed above under the heading “Device Configuration.”
6If changes are required, save those changes and exit.
7Remove the Intel EtherExpress software driver diskette and reboot the machine.
