Using the Management Application

Configuration

Configuring policy filters

Policy filters can be used to specify the IP addresses and ports of flows to be protected by HP Velocity, and the level of protection applied to the filtered flows. For more information, see Table 5 on page 32.

The following formats must be used when configuring the policy filters. Other formats will generate an error message:

•IP Address: Use a space-separated list of CIDR-format IP addresses and subnet mask pairs. For example, 192.168.1.0/24 145.76.53.3/32.

•Port: Use a space-separated list of ports. For example, 80 1750 1751.

NOTE: For a list of commonly used port numbers and brief descriptions of their related service names, see http://en.wikipedia.org/wiki/ List_of_TCP_and_UDP_port_numbers.

Figure 27. Policy Filters configuration dialog

HP Velocity Server Side Deployment Guide

60