Using Authorized IP Managers
Defining Authorized Management Stations
Similarly, the next command authorizes
ProCurve(config)# ip
If you omit the <mask bits> when adding a new authorized manager, the switch automatically uses 255.255.255.255 for the mask. If you do not specify either Manager or Operator access, the switch automatically assigns the Manager access. For example:
Omitting a mask in the ip
Figure
To Edit an Existing Manager Access Entry. To change the mask or access level for an existing entry, use the entry’s IP address and enter the new value(s). (Notice that any parameters not included in the command will be set to their default.):
ProCurve(config)# ip
The above command replaces the existing mask and access level for IP address 10.28.227.101 with 255.255.255.0 and operator.
The following command replaces the existing mask and access level for IP address 10.28.227.101 with 255.255.255.255 and manager (the defaults) because the command does not specify either of these parameters.
ProCurve(config)# ip
address of the authorized manager you want to delete:
ProCurve(config)# no ip