|
| Configuring |
|
| 802.1X Open VLAN Mode |
|
| |
Note | If you want to implement the optional port security feature on the switch, you | |
| should first ensure that the ports you have configured as 802.1X authenticators | |
| operate as expected. Then refer to “Option For Authenticator Ports: Configure | |
| ||
| After you complete steps 1 and 2, the configured ports are enabled for 802.1X | |
| ||
| authentication (without VLAN operation), and you are ready to configure | |
| VLAN Operation. | |
| Configuring 802.1X Open VLAN Mode. Use these commands to actually | |
| configure Open VLAN mode. For a listing of the steps needed to prepare the | |
| switch for using Open VLAN mode, refer to “Preparation” on page | |
| Syntax: | aaa |
Configures an existing, static VLAN to be the Authorized-
Client VLAN.
[<
Configures an existing, static VLAN to be the Unauthorized
For example, suppose you want to configure 802.1X
■ These two static VLANs already exist on the switch:
• Unauthorized, VID = 80
• Authorized, VID = 81
■ Your RADIUS server has an IP address of 10.28.127.101. The server uses rad4all as a
■ The switch's default VLAN is already configured with an IP address of 10.28.127.100 and a network mask of 255.255.255.0
ProCurve(config)# aaa authentication
Configures the switch for 802.1X authentication using an
ProCurve(config)# aaa
Configures ports A10 - A20 as 802.1 authenticator ports.
ProCurve(config)# radius host 10.28.127.101 key rad4all