HP Q153090901 manual 162

Code		Description	Explanation
3E	00h	Logical unit has not self-configured	The drive has just powered on and has not completed its
		yet	self-test sequence, so it cannot process commands.
3F	01h	Firmware upgraded	The firmware in the drive has just been changed by a Write
			Buffer command.
3F 05h		Device identifier changed	The Device ID has been changed successfully.
3F	0Fh	Echo buffer overrun	A Read Buffer command has been received with Echo
			Buffer mode set, and the echo buffer has been overwritten
			by a different host from that which issued the Read Buffer
			command.
3F	11h	Media Auxiliary Memory	MAM is accessible but the cartridge is in the Hold
		accessible	position. Unit Attention is generated.
40	XXh	Diagnostic failure on	A diagnostic test has failed. The Additional Sense Code
		component XX	Qualifier is a vendor-specific code indicating the failing
			component.
43	00h	Message error	A message could not be sent or received because of
			excessive transmission errors.
44	00h	Internal target failure	A hardware failure has been detected in the drive that has
			caused the command to fail.
45	00h	Select or reselect failure	An attempt to reselect an initiator in order to complete the
			command has failed.
47	00h	SCSI parity error	A command failed because of an excessive number of
			parity errors on the SCSI interface.
47	01h	Data phase CRC error detected	For parallel SCSI only in non-Information Units mode, the
			drive has detected a CRC error during the data out phase.
47	03h	Information Unit CRC error detectedFor parallel SCSI only in Information Units mode, the drive
			has detected a CRC error during the command IU or data
			out phase.
48	00h	Initiator Detected Error message	A command failed because an Initiator Detected Error
		received	message was received.
49	00h	Invalid message error	The command failed because an invalid message was
			received by the drive.
4A 00h		Command phase error	A command could not be executed because too many
			parity errors occurred in the command phase
4B	00h	Data phase error	A command could not be completed because too many
			errors occurred during the data phase.
4B	90h	Data phase error	FCL_DL to CDB Allocation Length mis-match.
4E	00h	Overlapped commands attempted	An initiator selected the drive even though it already had a
			command outstanding.
50	00h	Write append error	A write-type command failed because the point at which to
			append data was unreadable.
51	00h	Erase failure	An erase command failed to erase the required area on
			the tape.
52	00h	Cartridge fault	A command could not be completed because of a fault in
			the tape cartridge.
53	00h	Media load or eject failed	An attempt to load or eject the tape failed because of a
			problem with the tape.
53	02h	Medium removal prevented	An Unload command has failed to eject the tape because
			medium removal has been prevented.
55	03h	Insufficient resources

162 Commands