Selecting the UPS voltage configuration | HP T1000 guide

2.Connect the negative (black) lead to the negative battery terminal.

NOTE: A small amount of arcing may occur when connecting the batteries. This is normal and does not damage the unit or present any safety concern.

3.Replace the UPS front bezel.

Selecting the UPS voltage configuration

Using a small tool, position the DIP switches according to the desired voltage configuration as identified on the rear panel of the UPS and in the following table.

NOTE: The DIP switches must be set before powering up the unit. The unit does not change operating modes while powered up.

NOTE: An asterisk (*) indicates the default setting.

Output voltage

Input voltage range

DIP switch 2

DIP switch 1

Installation 14

Image 14

HP T1000 manual Selecting the UPS voltage configuration

Contents

HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index This section Component identificationUPS front panel UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Electrical requirements InstallationPrecautions Checking the battery recharge date Connecting the batteries Selecting the UPS voltage configuration Connecting the host computer Connecting the serial communications port Connecting the Network Transient Protectors Connecting the USB communications port Charging the UPS batteries Connecting the UPS to utility powerConnecting devices to the UPS Powering up the UPS Audible alarm conditions Silencing an audible alarmPowering down the UPS UPS operations UPS operations Power management HP Power Manager features Battery care and storage guidelines MaintenanceImportant battery safety information Updating the UPS firmware Replacing the batteries UPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance UPS operates on battery only TroubleshootingAudible alarm sounds UPS does not start Power LED flashes UPS frequently switches between utility and battery powerUPS does not provide the expected backup time Voltage Configuration LED is green Site Wiring Fault LED is red Battery Charge LED is redBattery Warning LED is amber Output Load Level LED is red or flashing red T1500 physical specifications SpecificationsT1000 physical specifications UPS input specifications T1000 power protection specifications T1000 output specificationsT1500 output specifications T1500 power protection specifications Battery specifications Output tolerance specificationsOutput feature specifications Battery runtimePage Spares T1000 UPS spare parts listT1500 UPS spare parts list Ordering spares HP contact information Technical supportBefore you contact HP $250,000 Computer Load Protection Guarantee Warranty informationLimited warranty Pre-Failure Battery Warranty Notification from power management software Federal Communications Commission notice Regulatory compliance noticesRegulatory compliance identification numbers FCC rating label Class a equipment Class B equipment Canadian notice Avis Canadien ModificationsCables European Union regulatory notice Japanese notice Bsmi notice Korean notice Battery replacement noticePower cord statement for Japan Grounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index Index Index