OPERATING
Operation
Loading Paper
•Pull open the tray you wish to load until it reaches the stop or remove it completely for more convenient loading.
•Obtain a fresh ream of paper. Best results will be obtained using regular copier or laser printer paper (see "Paper Quality Guidelines").
Hold the ream on the long edge and bend it in and out. Repeat on the short edge. Square it off properly (Fig. 14).
•Load letterhead paper face down, with the letterhead towards the right side.
Note:
Duplex printing requires different loading of preprinted paper (please also refer to the instructions in the printer manual). An additional TowerFeed tray will allow to have the same (preprinted) paper in two different trays and available online for regular and duplex printing.
•Insert approx. one third of the ream in the tray and ensure that all paper is lined up with the rear stop. Repeat two more times for the rest of the ream (Fig. 15).
•Push down the stack, such that all sheets are under the separation corners (Fig. 16).
•The right paper guide can be adjusted by pushing the separation corner tab to the left to ensure proper guiding of the paper.
•Push down on the paper stack a few times. The paper must move up and down freely.
Note:
For your convenience, you may insert a sample piece (about 1 inch/28 mm) of the loaded paper type into the extrusion as a reference when reloading the tray (Fig. 17).
•Close the tray. Repeat the procedure for all trays to be loaded.
Fig. 14 Fanning the Paper
Fig. 15 Filling in Paper
Fig. 16 Correct Paper Loading
Paper Sample
Fig. 17 Marking the Tray
IU 661 / 0047 | 11 | TowerFeedTM for the HP LaserJet 8150/8100/8000 |
|
|
|
