Pen holder and pen eject assembly
Description | Spare part number |
|
|
Pen holder and pen eject assembly | |
|
|
Before removing the pen holder and pen eject assembly, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power cord.
4.Remove the battery (see Battery on page 39).
5.Remove the following components:
a.Pen (see Pen on page 40)
b.Hard drive (see Hard drive on page 41)
c.Memory module compartment cover (see Memory module on page 44)
d.Optical drive (see Optical drive on page 43)
e.Keyboard (see Keyboard on page 49)
f.Switch cover (see Switch cover on page 51)
g.Display assembly (see Display assembly on page 53)
h.Top cover (see Top cover on page 56)
i.Power switch assembly (see Power switch assembly on page 59)
j.System board (see System board on page 62)
Remove the pen holderand pen eject assembly:
1.Remove the Phillips PM2.0×3.0 screw (1) that secures the pen eject assembly to the base enclosure.
2.Remove the pen eject assembly (2).
3.Remove the two Phillips PM2.0×3.0 screws (3) that secure the pen holder to the base enclosure.
Component replacement procedures 65
