Before connecting devices, verify that the UPS will not overload by checking that the ratings of the devices do not exceed the UPS capacity. If the equipment rating is listed in amps, multiply the number of amps by the selected output voltage to determine the VA.
After verifying that the UPS will not overload:
•Connect the device power cords to the output receptacles on the rear panel of the UPS (NA/JPN/TWN model).
•Connect devices to the output receptacles on the rear panel of the UPS using the jumper cords included with the UPS (INTL model).
Powering up the UPS
Press and hold the Power On/Standby button (1) until the UPS beeps. The Power On, Load 1 and Load 2 LEDs illuminate, indicating that power is available at the UPS output receptacles.
Charging the UPS batteries
With the UPS in Standby mode (on page 23), allow the batteries to charge before putting the UPS into service.
IMPORTANT: Charge the batteries for at least 24 hours before supplying backup power to devices. The batteries charge to:
•90% of their capacity within 4 hours
•100% of their capacity within 24 hours
