HP XC System 2.x Software manual Exiting TotalView, $ squeue, $ scancel --user username

5.In a few seconds, the TotalView Process Window will appear, displaying information on the srun process. In the TotalView Root Window, click Attached (Figure 4-5). Double-click one of the remote srun processes to display it in the TotalView Process Window.

Figure 4-5: Attached Window

6.At this point, you should be able to debug the application as in Step 8 of Section 4.2.1.6.

4.2.1.8Exiting TotalView

It is important that you make sure your job has completed before exiting TotalView. This may require that you wait a few seconds from the time your job has completed until srun has completely exited.

If you exit TotalView before your job is completed, use the squeue command to check that your job is not still on the system.

$ squeue

If it is still there, use the following command to remove all of your jobs:

$ scancel --user username

If you desire to cancel just certain jobs, refer to the scancel manpage for information about selective job cancellation.

Debugging Applications 4-11