LUBRICATION
Steering Control Shafts
Tip the driver’s seat.
Lubricate with a grease gun, one zerk for each steering control shaft, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
Mower Deck Struts
Lubricate with a grease gun, one zerk for each strut, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
Lubricating the steering control shafts
Lubricating struts
Oil Filter
1. Drain the engine oil in accordance with the work description under the heading “Engine Oil/Change Engine Oil”.
2. Remove the oil filter. If necessary, use a filter remover.
3. Wipe new, clean engine oil onto the seal for the new filter.
4. Mount the filter by hand with a ¾ turn.
5. Run the engine warm, then check that there are no leaks around the oil filter seal.
6. Check the oil level in the engine, top up if |
|
| |
necessary. The oil filter holds 0.2 qt. (0.2 liters) of |
|
| |
oil. | |||
Changing the oil filter | |||
|
Husqvarna - 55