Hughes & Kettner 220-230V, 117V modell, 100V model manual Jacks and Controls

EDITION TUBE-MANUAL

1.0 JACKS AND CONTROLS

INPUT: Plug your guitar into this jack.

FOOTSWITCH: Plug a footswitch (e.g. the Hughes & Kettner TTY-1) into this jack when you want to change channels remotely. If you choose to use a footswitch, make sure that the CHANNEL SELECT switch is set to the CLEAN channel (yellow LED lights up).

VOLUME: This knob controls the CLEAN channel’s volume and saturation levels. Depending on your guitar’s output level, you can dial in fat, crunchy sounds at higher VOLUME settings.

YELLOW CHANNEL SELECT LED: Lights up to indicate the CLEAN channel is active.

CHANNEL SELECT BUTTON: This selector lets you change channels by pushing the button by hand as opposed to stomping on a footswitch, which is also an option.

RED CHANNEL SELECT LED: This one illuminates up to indicate the LEAD channel is active.

GAIN: Rotate this knob to determine the amount of distortion in the LEAD channel.

MASTER: Dial this knob to control the LEAD channel’s volume level.

EQ SECTION: The Bass, Mid and Treble knobs affect both channels. Mid and Treble influence one another, an attribute considered normal and desirable in a tube amp. Boosting treble decreases midrange honk and vice versa: jacking up the mids cuts back on the high-end shimmer.

REVERB: Controls the intensity of the on-board reverb effect.

POWER: The EDITION TUBE’s mains power switch.

MAINS IN: Connect the included Euro-norm mains cord to this socket. Ensure the amp's voltage rating matches your local AC power rating before you plug the cord into the wall outlet.

EXTERNAL SPEAKER: Use this jack to connect external speaker enclosures with an overall impedance ranging from 8 to 16 ohms (an 8-ohm cabinet, for example, would work nicely). The internal loudspeaker remains in operation.

RETURN: Connect this jack to the output of your signal processor.

SEND: Connect this jack to the input of your signal processor.

6