WARP 7 - MANUAL
6.2The WARP 7™ is cabled up and connected properly, but no sound is audible:
•One or several GAIN or MASTER controls is/are turned all the way down. Dial in a higher setting.
•Your guitar cord may be defective; try another cord.
•A short circuit in the speaker signal chain may have tripped an internal fuse. Make sure none of the connections are shorted out and have a qualified service technician replace the fuse.
6.3 Your footswitch will not switch channels:
•The footswitch cord’s plug is not inserted pro- perly into the jack,
•Check if you connected a suitable footswitch. We recommend the
6.4When in use, the
•An electrical or magnetic field is causing inter- ference. Use cables of a higher quality or rearrange the cables you are using to reduce interference to a minimum. If this still doesn't improve the situation, use a DI box.
•The connected devices’ ground circuit may be causing a ground loop. At least one device’s
connection must be galvanically using a DI box or transformer.
CAUTION: Under no circumstances should you sever the ground of the connected devices!
6.5The signal is totally distorted when you connect an FX device (even when you dial in a clean sound).
•The effector’s input is being overdriven. Decrease the processor‘s input sensitivity by backing off its input or gain knob.
6.6The output signal level drops considerably when you connect an effect device.
•The FX processor's output level is set to too low a level. Turn it up
7.0 TECHNICAL SPECIFICATIONS
Preamp section: |
|
INPUT: | |
FX SEND: | +6 dBV/270 ohms |
FX RETURN: | 0 dB/220 ohms |
Power amp:
'CURRENT FEEDBACK' solid state power amp
Output power: | 100 watts RMS at 4 ohms |
| (2x 12” combo and head) |
| 80 watts RMS at 4 ohms |
| (1x 12” combo) |
Headphones out: | 100 mW at 4 – 600 ohms |
Frequency response: | 20 Hz - 30 kHz |
Combos:
Celestion® Hot 100 1x 12” and 2x 12” versions
Speaker Cabinet:
4 CELESTION RockDriver 12”Junior speakers
200 watts RMS at 8 ohms
GENERAL DATA:
Voltage: | 230 V~ (European model) |
| 117 V~ (North American model) |
| 100 V~ (Japanese model) |
Max. power consumption: | |
175 VA at 4 ohms |
|
Mains fuse: |
|
T 500 mA | (230 V model) |
T 1000 mA | (117 V model) |
T 1000 mA | (100 V model) |
Internal fuses: | 2x T2A |
Dimensions (W x H x D): |
|
1x 12” Combo: | 590 x 500 x 320 mm |
2x 12 Combo”: | 654 x 565 x 330 mm |
Head: | 610 x 235 x 255 mm |
Speaker cabinet: | 765 x 825 x 345 mm |
Weight: |
|
1x 12” Combo: | 20 kg |
2x 12 Combo: | 26 kg |
Head: | 9 kg |
Speaker cabinet: | 38 kg |
10
