Trolling Motor Transducer Installation
If you want to install your transducer on a trolling motor, use this procedure. Several styles of the transducer are compatible with trolling motor mounting. If you have a trolling motor bracket, refer to the separate installation instructions that are included with the bracket.
Trolling Motor Transducer Options
If you don’t have a trolling motor transducer, there are several options:
• You may purchase a Trolling Motor Adapter kit that will allow you to mount the transducer on the trolling motor.
•You may also exchange your NEW and UNASSEMBLED transducer (with mounting hardware included) for a trolling motor transducer.
There are also several transducer switches available that support the following configurations:
•Two control heads with one transducer
•Two transducers with one control head.
NOTE: Call the Humminbird® Customer Resource Center at
GPS Receiver Installation
To optimize performance of the GPS receiver, mount it in an area that has full exposure to the sky. The effective area of reception is 10° above the horizon. Different circumstances determine the mounting method appropriate for your GPS receiver.
If you have… | Then use: |
An existing antenna stem with standard 1" – | Stem Mount with Existing |
14 thread stem | 1” - 14 Thread Stem |
Access for cable routing under the mounting | Access Under Mounting Location |
location |
|
No access under the mounting location | No Access Under Mounting Location |
The pinouts of the NMEA cable are as follows:
•Red Wire, +12V (output voltage only)
•Black Wire, Ground
•White Wire, NMEA Out.
CAUTION! Please use caution before connecting the red +12V wire to any other NMEA device. This is an output voltage provided by the control head and GPS receiver and should only be connected to those NMEA devices that need a 12 volt input.
40