.

m

.com

www.reelschel

atic.

 

 

The 900 Series™ has a wide variety of configurations.

 

 

 

 

 

 

 

2

 

 

1

 

 

3

 

 

 

 

8

 

 

4

 

 

 

 

6

 

 

 

7

 

 

5

Accessory Bus

 

 

 

 

1

Sonar Transducer w/Temperature

Speed through water

5

2

Optional “Y” Cable

GPS Receiver

6

3

Power

WeatherSense®

7

4

Temperature/Speed

SmartCast® Wireless Sonar Link

8

Inside the boat there is often a channel or conduit used for other wiring, this can be used to route cables. Be sure to route the cable as far as practical from the antenna cable of VHF radios or tachometer cables to reduce the possibility of interference. The transducer and GPS receiver cables should not be cut, and care should be used not to damage the cable insulation.

Basic installation tasks that you must perform include:

Installing the control head (choosing either gimbal or in-dash mounting, where in-dash mounting requires a separate purchase)

Installing the transducer (choosing either the transom mount, inside the hull mount, or trolling motor mounting method)

Installing the GPS Receiver (if included)

Testing the complete installation and locking the transducer position.

NOTE: Accessories may require a separate purchase. You can visit our website at www.humminbird.com to order these accessories online or contact our Customer Resource Center at 1-800-633-1468.

Control Head Installation

You have two choices for mounting your 900 Series™ control head, Gimbal mounting, where you use a surface on the boat, such as the dash, to mount the control head so that it can be tilted up or down, or In-dash mounting, which requires a separate purchase.

6

Page 14
Image 14
Humminbird 957C manual Control Head Installation, Basic installation tasks that you must perform include