Manuals / Hunter Fan / Household Appliance / Fan

Hunter Fan 43045 D1 D2, Section D - Existing Construction - accessible from below, Existing Fan

Models: 82043 43045

1 18

Download 18 pages 43.47 Kb

Page 12

Image 12

Vaya a la sección E – Instalación Final en la página 14.

Section D - Existing Construction – accessible from below

D1 D2

Remove one of the wiring access slugs on the top of the housing. Use a second wiring access plug if needed.

Remove the mounting rail brackets.

D3	EXISTING FAN

3”

Remove an existing fan and check to make sure the opening		Run the power supply wire through the strain relief, leaving 3”
is large enough to accommodate the new fan housing. If		between the end of the wire and the strain relief. Tighten the
there is no existing fan choose an appropriate location to		strain relief around the wire.
make an 11” x 9 5/8” opening.	12
43045-
43045-	01 10/15/2009

Page 12

Image 12

Hunter Fan 43045, 82043 manual D1 D2, Section D - Existing Construction - accessible from below, Existing Fan

Contents

READ and SAVE THESE INSTRUCTIONS Energy Star Bath Fan ModelsFigure A 43045-01 210/15/2009W a r n i n g TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE FOLLOWING43045-01 310/15/2009 Before Installation 43045-01 410/15/2009Housing Wiring CoverChoose Installation Option For New Construction - attaching to joist, go to step A1, page43045-01 510/15/2009 Remove the fan assembly from the housingA1 OR Section A - New Construction - attaching to joist43045 Pop out a wiring access slugB1 OR Vaya a la sección E - Instalación Final en la páginaSection B - New Construction - suspended between joists 43045-01 710/15/2009Mark position of screws by using holes as a template 430451/16” bit Drill a pilot hole at the TOP of each outlineSection C - Existing Construction - accessible from above NO EXISTING FAN43045-01 Vaya a la sección E - Instalación Final en la páginaC2 OR C5C643045-01 10/15/2009 Pop out a wiring access slugC9C10 4304510/15/2009 head and the joist. Screws are suppliedSection D - Existing Construction - accessible from below D1 D2EXISTING FAN Vaya a la sección E - Instalación Final en la páginaMove the housing into the ceiling Install the wiring and the strain relief into the wiring accessVaya a la sección E - Instalación Final en la página 43045-01 10/15/2009Section E - Final Installation Connect the wiring as shownInstall the wiring cover box. Make sure all wiring connec tions are inside the wiring cover boxInstall the strain relief bracket. DO NOT ALLOW THE Plug in wiring harness43045-01 10/15/2009 screwsInstall light bulbs Install night lightInstall light bulb cover Restore power at the sourcePreventative Maintenance MaintenanceTrouble Shooting 43045-01 10/15/2009Trouble Shooting cont Warranty43045-01 10/15/2009