Manuals / Hunter Fan / Household Appliance / Fan

Hunter Fan 82043 manual Section C - Existing Construction - accessible from above, No Existing Fan

Models: 82043 43045

1 18

Download 18 pages 43.47 Kb

Page 9

Image 9

B10

B11

Install the wiring and the strain relief into the wiring access	Connect 6” duct and vent to the outside. Use duct tape to
hole you made earlier.	secure joints. If ducting does not fit securely, an adapter
	may need to be purchased.

Vaya a la sección E – Instalación Final en la página 14.

Section C - Existing Construction – accessible from above

C1
11”	9	⁄”	OR
		⁄”

NO EXISTING FAN

Remove an existing fan and check to make sure the opening
is large enough to accommodate the new fan housing. The
opening needs to be 11” x 9 5/8”.	910/15/2009
43045-01	910/15/2009

Page 9

Image 9

Hunter Fan 82043 manual Section C - Existing Construction - accessible from above, No Existing Fan, 43045-01

Contents

Energy Star Bath Fan Models READ and SAVE THESE INSTRUCTIONS43045-01 210/15/2009 Figure AW a r n i n g TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE FOLLOWING43045-01 310/15/2009 43045-01 410/15/2009 Before InstallationHousing Wiring CoverFor New Construction - attaching to joist, go to step A1, page Choose Installation Option43045-01 510/15/2009 Remove the fan assembly from the housingSection A - New Construction - attaching to joist A1 OR43045 Pop out a wiring access slugVaya a la sección E - Instalación Final en la página B1 ORSection B - New Construction - suspended between joists 43045-01 710/15/200943045 Mark position of screws by using holes as a template1/16” bit Drill a pilot hole at the TOP of each outlineNO EXISTING FAN Section C - Existing Construction - accessible from above43045-01 Vaya a la sección E - Instalación Final en la páginaC5C6 C2 OR43045-01 10/15/2009 Pop out a wiring access slug43045 C9C1010/15/2009 head and the joist. Screws are suppliedD1 D2 Section D - Existing Construction - accessible from belowEXISTING FAN Vaya a la sección E - Instalación Final en la páginaInstall the wiring and the strain relief into the wiring access Move the housing into the ceilingVaya a la sección E - Instalación Final en la página 43045-01 10/15/2009Connect the wiring as shown Section E - Final InstallationInstall the wiring cover box. Make sure all wiring connec tions are inside the wiring cover boxPlug in wiring harness Install the strain relief bracket. DO NOT ALLOW THE43045-01 10/15/2009 screwsInstall night light Install light bulbsInstall light bulb cover Restore power at the sourceMaintenance Preventative MaintenanceTrouble Shooting 43045-01 10/15/2009Trouble Shooting cont Warranty43045-01 10/15/2009