Husky 70 Series, 1800 Series manual GASBOY Series, Wall Mount

GASBOY Series 70 & 1820

Wall Mount

The optional wall mount kit can be used with any Series 70 or 1820 pump to be located remote from the tank. The wall mount kit consists of a wall mounting bracket, pump mounting flange, and hardware to attach the flange to the bracket. Hardware to attach the bracket to the wall is not included.

1.Fasten mounting bracket to wall using appropriate 3/8" fasteners (customer supplied).

2.Screw mounting flange to pump inlet. The flange with the four holes should be away from the pump. Pipe thread compound is not required. Tighten flange and align parallel with pump.

3.Bolt mounting flange to mounting bracket using the hardware supplied.

4.Remove the 1" plastic plug within the 2" pump base inlet and install the 1" inlet NPT inlet line from the tank into the pump. Apply gasoline-resistant pipe compound to male threads. Follow piping instructions shown on previous page for piping to the tank.

See the Conduit section for correct installation of electrical conduit.

2-8 9312