Husqvarna 1130SB-LSB owner manual Parts Packed Separately in Carton, Assembly / PRE-OPERATION

PARTS PACKED SEPARATELY IN CARTON

(1) FUEL STABILIZER PACKET

			(1) POWER CORD
			(198563)
			(1) AUGER CONTROL ROD				(1) SAFTEY IGNITION KEY
							(193071)
			(1) TRACTION DRIVE CONTROL ROD
(1) DISCHARGE CHUTE							(1) MULTI-
							WRENCH
	EXTRA SHEAR BOLTS AND NUTS						(180684)
(6) SHEAR BOLTS 1/4-20 x 1-3/4			(6) SPACERS	(6) LOCKNUTS
	(198636)		(198638)	1/4-20
				(73800400)
	ROTATOR HEAD MOUNTING
						(3) RETAINER	(2) FLAT WASHERS
						SPRINGS
						(169675)
(1) WASHER 3/8		(1) LOCKNUT 3/8					(2) CARRIAGE BOLTS
(19131316)		(73800600)
							3/8-16 x 2.25
		CHUTE DEFLECTOR REMOTE CONTROL
							(2) HANDLE KNOBS
(1) LOCKNUT	(1) CARRIAGE BOLT		(1) LOCKNUT	(1) NYLON		(1) SHOULDER	(1) SPRING
5/16-18	5/16-18 x 5/8		1/4-20	WASHER		BOLT 1/4-20
(751153)	(72250505)		(191730)	(179246)		(179829)	(184505)
	ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety					2.	Cut down all four corners of carton and lay panels flat.
before you attempt to assemble or operate your new					3.	Remove the two (2) screws securing the auger housing
snow thrower. Reading the entire manual will familiar-
						to the pallet.
ize you with the unit, which will assist you in assembly,
					4.	Remove all packing materials except plastic tie holding
operation and maintenance of the product.
						speed control rod to lower handle.
Your new snow thrower has been assembled at the factory
					5. Remove the two (2) plastic ties securing the upper
with the exception of those parts left unassembled for ship-
						handle to the pallet.
ping purposes. All parts such as nuts, washers, bolts, etc.,
					6. Remove snow thrower from carton and check carton
necessary to complete the assembly have been placed in
the parts bag. To ensure safe and proper operation of your						thoroughly for additional loose parts.
snow thrower, all parts and hardware you assemble must					HOW TO SET UP YOUR SNOW THROWER
be tightened securely. Use the correct tools as necessary
to ensure proper tightness.					TOOL BOX (See Fig. 10)
REMOVE SNOW THROWER FROM CARTON					A toolbox is provided on your snow thrower. The toolbox is
1. Remove all accessible loose parts and parts boxes					located on top of the belt cover. Store the extra shear bolts,
					nuts and multi-wrench provided in parts bag in the toolbox.
from carton.				4