MAINTENANCE
Checking of the fuel pump’s air filter
Check regularly that the fuel pump’s air filter is free from dirt.
The filter can when necessary be cleaned with a brush.
Check the level of the battery acid
Check that the level of the battery acid lies between the markings. Top up the cells with only distilled water.
WARNING!
Procedures on contact with acid
External: Rinse well with plenty of water.
Internal: Drink large quantities of water or milk. Contact a doctor as soon as possible.
Eyes: Rinse well with plenty of water. Contact a doctor as soon as possible.
Batteries emit explosive gas. Sparks, flames and cigarettes must absolutely not be brought into the vicinity of the battery.
Ignition system
The engine is equipped with an electronic ignition system. Only the spark plug requires maintenance.
For recommended spark plug, see chapter ”Technical data”.
IMPORTANT INFORMATION
Fitting the wrong spark plug type can damage the engine.
1.Remove the ignition cable shoe and clean around the spark plug.
2.Remove the spark plug with a 13/16" (21 mm) spark plug socket wrench.
3.Check the spark plug. Replace the spark plug if the electrodes are burned or if the insulation is cracked or damaged. Clean the spark plug with a steel brush if it is to be reused.
4.Measure the electrode gap with a gapping tool. The gap should be 0.75 mm/0.030". Adjust as necessary by bending the side electrode.
5.Reinsert the spark plug, turning by hand to avoid damaging the threads.
IMPORTANT INFORMATION
Inadequately tightened spark plugs can cause overheating and damage the engine. Tightening the spark plug too much can damage the threads in the cylinder head.
6.After the spark plug is seated, tighten it using a spark plug wrench so that the washer is compressed. A used spark plug should be turned
7.Replace the ignition cable shoe.
English – 25
