Lever for adjustment of cutting height, Seat | Husqvarna 16 instruction

PRESENTATION

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions (4-90 mm, 45-80 mm Bioclip).

Unit with side/rear ejection/Combi, 40-90 mm.

BioClip unit, 45-95 mm.

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

Release the knobs under the seat and adjust it forwards or backwards to the required position.

Lock the setting with the knobs.

Fuelling

The engine should be run on 85 octane (or higher) unleaded petrol/gasoline (no added oil). Environmentally adapted alkylate fuel is also recommended.

WARNING! Petrol/gasoline is highly inflammable. Observe care and fill up with fuel outdoors (see safety instructions).

6004-013H

6004-014H

6004-015

14 – English

Image 16

Husqvarna 16 manual Lever for adjustment of cutting height, Seat, Fuelling

Contents

Rider Svenska Contents Instruction Dear customerTravel and transport on public roads Towing Safety Instructions Good serviceSerial number Engine Transmission Explanation of Symbols Safety instructions General use Keep children away from the area to be mowed Driving on slopes Proceed as follows Maintenance Children Do not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unit Seat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release lever Maintenance Maintenance scheduleDaily Maintenance interval Hours Dismantling of the machine hoods Engine hoodFront hood Right-hand fender Adjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filter Do not use compressed air to clean the paper filter Replacing the air filter Check the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Ignition system Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intake Fitting the cutting unit Installing BioClipObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Replacing the cutting unit belts Belt change on BioClip 6016-111 Service position for cutting unit Placing in service position 6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Trouble Shooting Schedule Problem Procedure Storage ServiceWinter storage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to Europe Servicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, sign Servicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00