Presentation, Location of the controls | Husqvarna 16 specs

PRESENTATION

Presentation

Congratulations on your choice of a top quality product which you will enjoy for many years.

These instructions describe the Rider 16. This rider mower is equipped with a 15.5 horsepower Briggs & Stratton engine.

The power transmission from the engine is handled by a hydrostatic gear box which enables stepless varia- tion of the speed with the foot pedals.

There is one pedal for driving forwards and one pedal for reversing.

Location of the controls

1.Ignition lock

2.Throttle/Choke lever

3.Adjustment of cutting height

4.Lifting lever, cutting unit

5.Speed limiter for reversing

6.Speed limiter for driving forwards

7.Parking brake

8.Lock button for parking brake

9.Knobs for adjusting seat

10.Fuel tank cap

11.Main lock (under seat)

12.Lever for disengagement of drive

English – 11

Image 13

Husqvarna 16 manual Presentation, Location of the controls

Contents

Rider Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Good service Safety InstructionsSerial number Engine Transmission Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unit Seat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engine Maintenance schedule MaintenanceDaily Maintenance interval Hours Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Adjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wire Replacing the air filter Do not use compressed air to clean the paper filter Procedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition system Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressure Fitting the cutting unit Installing BioClipObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Belt change on BioClip Replacing the cutting unit belts 6016-111 Placing in service position Service position for cutting unit 6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, sign Servicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00