Restoring from service position | Husqvarna 16 specification

MAINTENANCE

WARNING!

Observe caution to avoid trapping your hand.

8.Lift off the drive belt (1). Then pull out the pin

(2).

1

2

6017-225

9. Pull the frame forwards and refit the pin.

10.Grasp the front edge of the cutting unit, pull out and raise into the service position.

If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.

Restoring from service position

To leave the service position, reverse the procedures set out in “Placing in the service position”. Make sure that the cutting unit’s ”lug” enters the loop correctly on the underside of the machine, see diagram.

6017-226

6017-227

8009-123

English – 35

Image 37

Husqvarna 16 manual Restoring from service position, Observe caution to avoid trapping your hand

Contents

Rider Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Good service Safety InstructionsSerial number Engine Transmission Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unit Seat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engine Maintenance schedule MaintenanceDaily Maintenance interval Hours Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Adjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wire Replacing the air filter Do not use compressed air to clean the paper filter Procedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition system Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressure Fitting the cutting unit Installing BioClipObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Belt change on BioClip Replacing the cutting unit belts 6016-111 Placing in service position Service position for cutting unit 6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, sign Servicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00