Check the transmission’s oil level | Husqvarna 16 instruction

LUBRICATION

Check the transmission’s oil level

1.Remove the transmission cover. Loosen both screws (one on each side) and lift off the trans- mission cover.

2.Check that there is oil in the transmission’s oil tank. Fill if necessary with engine oil SAE 10W/ 30 (class SF–CC).

6008-039H

6008-240H

Lubricating the belt adjuster

The belt adjuster should be lubricated regularly using good quality molybdenum disulphide grease*.

1 nipple from the right-hand side under the engine’s lower belt pulley, until grease is forced out.

With daily use lubrication should be conducted twice a week.

6008-232

General lubrication

All joints and bearings are lubricated on manufacture with molybdenum sulphide grease. Re-grease with same type of grease*. Lubricate the steering and control wires with engine oil.

The machine should be lubricated regularly, and twice a week when used daily.

*Grease from well-known brand names (petrol companies, etc.) usually maintains a good quality. The most important property is that the grease provides good protection against corrosion.

English – 39

Image 41

Husqvarna 16 manual Check the transmission’s oil level, Lubricating the belt adjuster, General lubrication

Contents

Rider Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Good service Safety InstructionsSerial number Engine Transmission Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Lift lever for cutting unit Cutting unit Fuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Release lever Stopping the engine Maintenance schedule MaintenanceDaily Maintenance interval Hours Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Poorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacement of the fuel filter Checking and adjustment of the throttle wire Replacing the air filter Do not use compressed air to clean the paper filter Procedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition system Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressure Observe caution to avoid trapping your hand Installing BioClipFitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Belt change on BioClip Replacing the cutting unit belts 6016-111 Placing in service position Service position for cutting unit 6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip Changing the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Problem Procedure Trouble Shooting Schedule Winter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, sign Servicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00