Husqvarna 260 ACX manual Trouble Shooting, Fault message, Cause, Action

9. TROUBLE SHOOTING

Fault message	Cause	Action
Outside working area	If this occurs in isolated areas it may	Try moving the boundary wire.
	be due to interference from metallic
	objects (perimeter fence,
	reinforcement bar) or buried cables in
	the vicinity.
	The working area slopes too much.	Check that the boundary wire has
		been routed correctly.
	The boundary wire has been routed	Check that the boundary wire has
	the wrong way around an island.	been routed in accordance with the
		installation instructions.
	The boundary wire is too close to the	Check that the boundary wire has
	edge of the working area.	been routed correctly.
Low battery voltage	Automower® cannot find the charging	Change the search settings
	station.	according to the Follow loop in (3-2-2)
		on page 51.
		Change the position of the charging
		station.
	The battery is spent.	Expected life is 1 - 4 years. Contact
		your dealer to replace the battery.
Wrong PIN code	Wrong PIN code has been entered.	Enter the correct PIN code.
	Three attempts are permitted, the
	keypad is then blocked for five
	minutes.
No drive	Automower® has got caught in	Free the mower and rectify the
	something.	reason for the lack of drive. If it is due
		to wet grass, wait until the lawn has
		dried before using the mower.
No contact in charging	Automower® makes poor contact with	Check that Automower® has docked
station	the contact strips in the charging	correctly in the charging station.
	station.
Charging station	The contact between the charging	Place Automower® in the charging
blocked	strips and contact strips may be poor	station and check that the charging
	and Automower® has made a number	strips and contact strips make good
	of charging attempts.	contact.
	An object is obstructing Automower®.	Remove the object.
Stuck in charging	An object is preventing Automower®	Remove the object.
station	from reversing out of the charging
	station.
Upside down	Automower® leans too much or has	Turn the mower the right way up.
	turned over.
Needs manual	Automower® is set in MAN operating	This behaviour is normal; no action
charging	mode.	required.
Check ultrasonic	Debris, dust or similar has clogged	Clean the two ultrasonic sensors on
	the ultrasonic sensor.	the mower's body.
	Automower® has collided at too great	Place boundary wire around
	a speed a number of times.	obstacles not discovered by the
		ultrasonic.

English - 71