Husqvarna 927SB Operation, TO MOVE FORWARD AND BACKWARD See Fig, TO THROW SNOW See Fig

OPERATION
HIGH	DISCHARGE CHUTE
POSITION
	CLEAN-OUT
	TOOL
KNOB	MOUNTING
	CLIP
CHUTE
DEFLECTOR
LOW POSITION	FIG. 15

	TO MOVE FORWARD AND BACKWARD (See Fig. 16)
FIG. 13
	SELF-PROPELLING, forward and reverse movement of
TO THROW SNOW (See Fig. 14)
The auger rotation is controlled by the auger control lever	the snow thrower, is controlled by the traction drive control
	lever located on the left side handle.
located on the right side handle.
	• Squeeze traction drive control lever to handle to engage
• Squeeze auger control lever to handle to engage the
	the drive system.
auger and throw snow.
	• Release traction drive control lever to stop the forward
• Release the auger control lever to stop throwing snow.
	or reverse movement of the snow thrower.
AUGER	SPEED and DIRECTION are controlled by the drive speed
	control lever.
CONTROL
LEVER	• Press downward on the speed control lever and move
	lever to desired position BEFORE engaging the trac-
	tion drive control lever. Be sure lever springs back and
	locks into desired position.

	CAUTION: Do not move speed control lever
	when traction drive control lever is engaged.
FIG. 14
	Damage to the snow thrower can result.
USING THE CLEAN-OUT TOOL (See Fig. 15)
	• Slower speeds are for heavier snow and faster speeds
In certain snow conditions, the discharge chute may be-
	are for light snow and transporting the snow thrower. It
come clogged with ice and snow. Use the clean-out tool
	is recommended that you use a slower speed until you
to dislodge this blockage.
	are familiar with the operation of the snow thrower.

When cleaning, repairing, or inspecting, make certain all controls are disengaged and the au- ger/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to prevent ac- cidental starting.

•Release the auger control lever and shut off the engine.

•Remove the clean-out tool from it's mounting clip. Grasp the tool firmly by the handle and push and twist the tool into the discharge chute to dislodge the blockage.

After the packed snow has been dislodged, return the clean- out tool to it's mounting clip by pushing it into the clip.

•Make sure the discharge chute is pointed in a safe di- rection (no vehicles, buildings, people, or other objects are in the direction of discharge) before restarting the engine.

TRACTION DRIVE

CONTROL LEVER

DRIVE SPEED

CONTROL LEVER

FIG. 16

•Restart the engine, then squeeze the auger control lever to the handle to clear snow from the auger hous-

ing and the discharge chute. 10