D1 | Assembly Instructions cont’ |
Grassbox Assembly | |
1. Position the two grassbox halves together (D1) and press | |
| each location point into position without fully connecting the |
| clips. |
D2 | 2. When the location points are matched correctly firmly press |
the grassbox together until all clips are securely connected. |
(D2) |
Cutting Height Adjustment
E1 |
E2 |
Cutting Height
The cutting height can be adjusted by removing the front and back wheels on the product.
1.Remove the wheel by turning the wheel hub in an anti- clockwise direction (E1) and relocate in new hole turn- ing the wheel hub in a clockwise direction to tighten
(E2). Repeat for other wheels adjusting to the same position.
POWERDRIVE VERSION
1.When the rear wheels are removed the height adjust- ment holes can be viewed by moving the drive wheel disc up and down,
Engine Notes
Oil
1.To fill with oil:-
a)Remove oil filter cap.
b)Fill to the FULL mark on the dipstick.
2.Use a good quality SAE 30 four stroke oil.
3.Check oil level periodically and after every five hours of operation.
4.Add oil as necessary to keep the level to the FULL mark on the dipstick.
5.Change the oil after the first five hours operation and thereafter every 25 working hours.
6.Always change the oil while the engine is warm - but not hot - never attempt any maintenance on a hot en- gine.
Refer to the Engine Operators Manual for further infor- mation.
Petrol
1.Use fresh regular grade lead free petrol.
2.NEVER USE LEADED PETROL
Using leaded petrol will make the exhaust smoke and cause irreparable damage to engines fitted with a cat- alytic converter.
3.Do not fill the fuel tank when the engine is hot.
4.Do not fill the fuel tank while smoking.
5.Do not fill the fuel tank while the engine is running.
6.To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it.
7.It is recommended that you fill the tank through a fun- nel with a filter.
8.Wipe away spillages before starting.
