03Connecting your equipment
10 AM and FM antenna terminals
Use to connect indoor or outdoor antennas for radio broadcasts.
Connecting antennas on page 19.
11 Multichannel
Use to connect separate amplifiers for front, center, surround, surround back and subwoofer channels.
Connecting additional amplifiers on page 45 (see also Installing your speaker system on page 17 for powered subwoofer connection).
12Composite and
Connecting your TV and DVD player on page 13.
13Multichannel analog audio inputs
7.1channel inputs for connection to a DVD player with multichannel analog outputs.
Connecting the multichannel analog inputs on page 43.
1412V trigger jack (total 50 mA max.)
Use to switch components in your system on and off according to the input function of the receiver.
Switching components on and off using the 12 volt trigger on page 48.
15
Use to connect a second amplifier in a separate room.
16 Speaker terminals
Use for connection to the main front, center, surround and surround back speakers.
Installing your speaker system on page 17.
17 Switched AC power outlet (100 W/0.8 A max.)
Use to power another component in the system. Power to the outlet switches on and off with the receiver.
AC outlet on page 20.
When making cable connections
•To avoid hum, do not lay connected cables over the top of the receiver.
•When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical socket.
•When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners.
About the video converter
When the video converter is enabled, all analog video sources are output through all of the MONITOR VIDEO OUT jacks (HDMI and
component video cannot be converted).1 See Video Converter Setup on page 52 to switch the video converter on or off.
If several video components are assigned to the same input function (see The Input Assign menu on page 50), the converter gives priority to component,
•For optimal video performance, THX recommends switching video conversion (in Video Converter Setup on page 52) OFF.
This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited consumer uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.
Note
1You must connect your monitor/TV to the receiver’s HDMI/component video outputs when connecting these video sources. If the video signal does not appear on your TV or plasma display, try adjusting the resolution settings on your component or display. Note that some components (such as video game units) have resolutions that may not be converted. In this case, use an (analog)
12
En
