Additional information

Specifications

Amplifier section

Continuous average power output of 110 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.09 %** total harmonic distortion (front).

Continuous Power Output (20 Hz to 20 kHz, 8 , 0.09 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W

Continuous Power Output (1 kHz, 6 , 1.0 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W

Total harmonic distortion. . . . . . . . . . . . . . . . . . . . . . . 0.09 % (20 Hz to 20 kHz, 110 W, 8 )

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Audio Section

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .335 mV/47 k

Frequency Response (LINE). . . . . . .5 Hz to 100 000 Hz dB Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/2.2 kTone Control

BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . .± 6 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . .± 6 dB (10 kHz) LOUDNESS. . . . . . . . . . .+4 dB / +2 dB (100 Hz/10 kHz)

(at volume position –40 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network) LINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103 dB

Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]

LINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83 dB

12

FM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Usable Sensitivity . . . . . . .Mono: 13.2 dBf, IHF (1.3 µV/75 ) 50 dB Quieting Sensitivity . . . . . . . . . . . . . . . Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio . . . . . . . . . . . . Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf)

Distortion . . . . . . . . . . . . . . . . . . . . . . . . Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity . . . . . . . . . . . .60 dB (400 kHz) Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . .40 dB (1 kHz) Frequency Response . . . . . . . . . . . . . 30 Hz to 15 kHz ± 1dB Antenna Input . . . . . . . . . . . . . . . . . . . . . . . 75 unbalanced

AM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . . 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna) . . . . . . . . . . . . . . . . 350 µV/m Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power Requirements. . . . . . . . . . . . . . . . . . . .AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . 490 W, 650 VA In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W AC Outlet . . . . . . . . . . . . . . . . . . . . . . (switched) 100 W MAX. Dimensions . . . . . .420 (W) mm x 173 (H) mm x 466 (D) mm

(16 9/16 (W) in. x 6 13/16 (H) in. x 18 3/8 (D) in.) Weight (without package). . . . . . . . . . . . 15.0 kg (33 lbs 1 oz)

Furnished Parts

Setup microphone (for Auto MCACC setup). . . . . . . . . . . . . 1 AA/IEC R6P dry cell batteries . . . . . . . . . . . . . . . . . . . . . . . 2 Remote control unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

Composite Video / S-Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . .5 Hz to 10 MHz

Component Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . .5 Hz to 100 MHz

Cleaning the unit

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

71

En

Page 71
Image 71
Classe Audio VSX-80TXV-S manual Additional information Specifications, Cleaning the unit