Technical data | Operator's Manual CS 2512 |
Technical data
Power on drive wheel (with PP 455): ____ 20 kW
Hydraulic oil flow: ___________________ 65l/min (17 gal/min)
Max permitted hydraulic pressure ______ 230 bar (3400 psi)
Max recommended hydraulic
pressure when cutting: _______________ 130 bar (1900 psi)
Maximal wire length in the magazine: ___ 12 m
(2.4 m/wheel set)
Dimensions, handle folded in and
the guard folded down (L x W x H) ______ 1150x750x980 mm
Weight: ___________________________ 150 kg ( 330lbs)
Wire speed gear 1 __________________ 20 m/s (66 ft/s)
Wire speed gear 2 __________________ 25 m/s (82 ft/s)
WARNING
Under no circumstances may modifications be made to the machine without written permission from Husqvarna Construction Products Sweden AB. Non approved modifications put you and others at risk of serious or fatal injuries. Husqvarna Construction Products Sweden AB bears no responsibility for operations that do not conform to these instructions.
Recommended wires:
Husqvarna recommends that the following wires are used:
•Husqvarna C710C
Husqvarna C710C is a galvanised wire developed for use when cutting concrete with a great deal of reinforcement. The segments have a great number of diamonds and a smaller diameter (9.5mm) which means the wire cuts very efficiently. The smaller diameter also means that C710C can be used to finish difficult cuts.
•Husqvarna C750C
Husqvarna C750C is an all round wire developed for use when cutting reinforced concrete. The wire has been designed for use with saws with an output power between 10 and 25 kW.
•Husqvarna C760C
This is the Husqvarna premium wire: long life, high cutting rate and high power resistance characterize this wire. Husqvarna C760C can be used to cut all types of reinforced concrete, even when the work places high demands on the wire, for example when cutting bridges.
•Husqvarna C790C
The segment strength on this wire makes Husqvarna C790C the best choice when cutting soft materials such as mortar, and lightly reinforced limestone concrete.
•Husqvarna C575J
Husqvarna C575J is a wire with galvanised 15 mm segments.
Husqvarna C1200M
HusqvarnaC1200M is a wire developed for use when cutting steel. The wire has been designed for use in extremely demanding situations. The use of the latest sintering technique has given enormous advantages with regard to cutting rates and life span. The wire can be supplied with either joined or loose ends.
For further information about different tools from
Husqvarna, contact your Husqvarna dealer.
10 - English
