Operator's Manual CS 2512 | Assembling/Installing equipment |
Connection to the hydraulic unit
When the saw is assembled appropriately, it should be connected to a hydraulic unit. Husqvarna CS 2512 is designed for use with Husqvarna PP 455 or Husqvarna RC 455.
1.Check that the hydraulic unit is connected to the power.
2.Connect the cooling water to the motor on the hydraulic unit.
3.Check that the display on the remote control shows “CONNECT HOSE BUNDLE”. If not follow the instruc- tions in the Operator's manuals for PP 455E or RC 455.
4.Fit the two large hydraulic hoses on the unit first and then to the saw motor connections. Lock the couplings by turning the sleeve on the coupling so that the slot moves away from the ball.
5.Fit the pressure reduction block on the hydraulic unit as set out in the instructions on the block.
6.Connect the two smaller hydraulic hoses to the pressure reduction block. The hoses in the hose bundle marked with a red disc by the coupling shall be connected to the hose on the pressure reduction block that is also fitted with a disc.
Lock the couplings by turning the sleeve on the coupling so that the slot moves away from the ball.
7.Fit the two hoses connected on the pressure reduction block to the hoses to the feed cylinder on the saw. The hoses in the hose bundle marked with a red disc by the coupling shall be connected to the hose on the saw that is also fitted with a disc.
8.Connect the water hose to the incoming water on the saw.
If the couplings jam when assembling, they should be removed completely before being refitted.
Make sure that the couplings on the hoses not in use do not lie directly on the ground.
Always keep the couplings as clean as possible. A clean coupling lasts longer.
Threading the wire
The guard can easily be lifted off to facilitate fitting wire. Now thread the wire as follows:
1.Make sure the magazine is in the min position.
2.Place the wire around the work piece, possibly through the predrilled holes and back to the saw.
3.Thread the wire through the hole by the swivel wheel and around a suitable number of wheel sets in the magazine.
4.Adjust the drive wheel unit according to the number of wheel sets used in the magazine:
Loosen the arm by screwing out the knob anti- clockwise. Now turn the drive wheel unit so that the arm is aligned with the markings on the saw. Lock the drive wheel unit by turning back the knob.
Usually only one wheel set is used in the first stage of cutting.
English - 13
