Assembling/Installing equipment | Operator's Manual CS 2512 |
Assembling/Installing equipment
Cutting needs to be planned carefully before assembling the saw so that it can be performed as easily as possible.
Husqvarna CS 2512 can be assembled to make either horizontal or vertical cuts. The saw is assembled standing when you wish to make vertical cuts.
The saw is assembled horizontally when the cut is to be made at floor height and when the cut is made in the floor.
When the saw is anchored to the floor, screw down the adjuster feet so that the saw stands firmly.
Remember that the machine's centre of gravity (the grey circle) is positioned between the first and second pairs of adjuster feet (the adjuster feet pairs are marked
A
B
It may be necessary to drill holes to thread the wire through the material to be cut.
Position the saw in an appropriate position in front of the planned cut. When the saw is in position, secure it by screwing down the anchor bolt.
1 | 2 | 3 |
If necessary, fit idler wheels to assist the cutting process. Using the idler wheels allows the number of sharp corners that the wire must be pulled around can be reduced, which results in less wear to the wire at the same time as cutting is made easier. Using the idler wheels also lets the wire be guided in different directions without the need of moving the saw unit.
Also, use the idler wheels to capture the wire when finishing the cut.
WARNING!
Always position the saw so that you can stand without the risk of being hit by a broken wire. Ensure that no unauthorised persons can access the working area while cutting. Being hit by a broken wire can result in death or serious personal injury.
12 - English
