Operation | Operator's Manual CS 2512 |
Operation
Sawing
When all the equipment has been assembled cutting can start. In order for the saw to cut as efficiently as possible it should be started as follows:
1.Close the valve on the pressure reduction block by turning the knob
2.Start the hydraulic unit.
3.Set the feeding flow on the unit to max by turning the control on the remote control clockwise.
4.Tension the wire by carefully turning the knob on the pressure reduction block clockwise until the wire is tensioned sufficiently. Make sure to always check that the wire is seated correctly in all the wheels on the saw.
5.Start the motor's rotation by turning the control for motor rotation on the remote control clockwise.
6.Carefully increase the motor speed by turning the control for motor rotation. A suitable working pressure when cutting usually lies between 100 and 130 bar, but varies depending on how many wheel sets are used in the magazine, how much wire is in use and the hardness of the material to be cut.
7.As the material is cut away the working pressure drops, which is shown on the display, and the magazine must then be tensioned. Do this by turning the knob on the pressure reduction block clockwise.
8.The output tension on the magazine is shown by an indicator on the machine (shown in the min position). When the magazine cylinder is fully tensioned, the machine must be stopped and the wire must be wound around a new wheel set. Then continue to cut as above.
CAUTION
In order for the water to cool the wire as intended during cutting, it is essential to adjust the position of the cooling water as the material is cut. Remember to always stop the machine when you do this.
Finishing sawing
1.Lower the speed on the wire and allow the motor to stop completely.
2.Fold up the magazine arm.
3.Disconnect the incoming mains cable from the hydraulic unit.
4.Disconnect the hydraulic hoses and the water hose from the saw unit.
5.Other steps are done in the reverse order.
14 - English
