Operator's Manual CS 2512 | Operation |
Cleaning
The saw should be cleaned once cutting is finished. It is important to clean all the saw equipment. It is a good idea to disconnect the water hose from the pivot arm and use this to wash down the saw unit. If necessary, you can also use the supplied cleaning brush or the like to clean the equipment. Do not use a high pressure washer to clean the saw.
Maintenance
In addition to the daily maintenance such as cleaning and lubrication, the machine must be serviced. After 50 hours of cutting, the machine should be serviced at an accredited Husqvarna workshop. The saw should then be serviced after every 100 hours of operation. The service is important so that as the user you have a machine that works as effectively as possible for a long time.
Lubrication
In order for the wire to run as friction free as possible, the magazine axles must be filled with grease. Fill with grease after every 5
The bearings on the magazine axles also need to be lubricated regularly, but not as often as the magazine axles.
English - 15
