Husqvarna R 50S / BBC, R 50SE Assembly Instructions, Maintenance and storage, Recoil Starter

Models: R 50SE R 50S / BBC R 50S

1 80
Download 80 pages 33.19 Kb
Page 9
Image 9
Maintenance and storage

Safety Precautions

Use

1.Do not operate the engine in a confined space where exhaust fumes (carbon monoxide) can collect.

2.Use the lawnmower only in daylight or good artificial light.

3.Avoid operating your lawnmower in wet grass, where feasible.

4.Take care in wet grass, you may lose your footing.

5.On slopes, be extra careful of your footing and wear non-slip footwear.

6.Mow across the face of slopes, never up and down.

7.Exercise extreme caution when changing direction on slopes.

8.Mowing on banks and slopes can be dangerous. Do not mow on banks or steep slopes.

9.Do not walk backwards when mowing, you could trip. Walk never run.

10.Never cut grass by pulling the mower towards you.

11.Stop the engine before pushing the mower across surfaces other than grass and when transporting the lawnmower to and from the area to be mowed.

12.Never operate the lawnmower with damaged guards or without guards in place.

13.Do not overspeed the engine or alter governor settings. Excessive speed is dangerous and shortens lawnmower life.

14.Disengage all blade and drive clutches before starting.

15.Keep hands and feet away from the cutting means at all times and especially when switching on the engine.

16.Do not tilt lawnmower when starting the engine

17.Do not put hands near the grass discharge chute whilst engine is running.

18.Never pick up or carry a lawnmower while the engine is running

19.Spark plug wire may be hot - handle with care.

20.Do not attempt any maintenance on your lawnmower when the engine is hot.

21.Stop the engine, and wait until the blade has

stopped:-

-before leaving the mower unattended for any period;

22. Release the Operator Presence Control to stop the engine, wait until the blade has stopped, disconnect the spark plug lead and wait until the engine has cooled:-

-before refuelling

-before clearing a blockage;

-before checking, cleaning or working on the appliance;

-if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition.;

-if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can

cause injury.

23.Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off

valve, turn the fuel off at the conclusion of mowing.

Maintenance and storage

1.Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition.

2.Check the grassbox/grassbag frequently for wear or deterioration.

3 Replace worn or damaged parts for safety.

4.Only use the replacement blade, blade bolt, spacer and impeller specified for this product.

5.Never store the lawnmower with fuel in the tank inside a building where fumes can reach an open flame or spark.

6.Allow the engine to cool before storing in any enclosure.

7.To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease.

8.If the fuel tank has to be drained, this should be done outdoors.

9.Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine.

Assembly Instructions

A2-a - handle adjuster

Handle Assembly

1.Your product is supplied with the handles folded over the product. (A1)

2.Loosen handle adjusters (A2) on both sides of the product and lift handle assembly up.

3.Adjust handle assembly to the most comfortable operating position (A3) and tighten handle adjusters (A2) on both sides of the product

Recoil Starter

1.Disconnect the spark plug lead.

2.Pull the Operator Presence Control (B1) to release the brake on the engine.

R 50S AND R 50SE ONLY.

You must release the brake by pulling the OPC lever to the handle before pulling out the cord.

3.Locate cord in the pull cord guide on the lower handle. (B2)

4.Locate cord in the pull cord guide on the upper handle. (B3)

Fitting the Grassbox

1.Lift safety flap. (C1)

2.Locate grassbox to machine. (C2)

3.Locate safety flap onto the top of the grassbox. (C3). Ensure the grassbox is securely located.

Please Note :- Ensure no gap remains between the safety flap and the grassbox

Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the safety flap is fully closed

ENGLISH - 2

Page 9
Image 9
Husqvarna R 50S Assembly Instructions, Maintenance and storage, A2-a - handle adjuster Handle Assembly, Recoil Starter