SEALING SPLASHGUARD TO FLOOR
IF REQUIRED by local sanitation codes, or if
desired by the customer, plastic splashguards may
be sealed to the floor using silicone type sealer.
The amount needed will depend on how much
the floor is out of level.
• Remove all dirt, wax and grease from the area of
the splashguard where adhesion will be necessary.
This is to ensure a good and secure installation.
• Apply a good silicone type sealer along the
bottom of the splashguard. Sealant must be
removed and replaced when servicing.
OPTIONAL Stainless steel splashguards may be
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how
much the floor is out of level.
To install the trim to the splashguard:
• Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be neces-
sary. This is to ensure a good and secure installa-
tion.
• Apply a good contact cement to the cove trim
and allow proper drying time according to the
directions supplied with the cement.
• Install the trim to the splashguard so that it is
lying flush with the floor. DO NOT SEAL THE TRIM
TO THE FLOOR.
•If required by local health codes Cove Trim
may be sealed to the floor using a silicone type
sealer. Sealant must be removed and replaced
when servicing.
Reach-In
P/N 0387183_D 3-3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Silicone-type
Sealer
Splashguard
Splashguard
Cove Trim
Cement