RLTwith GAS DEFROST ONLY:
REPLACING SECONDARY PLATE
HEATER
The secondary plate heater is located as
shown below.
Remove Secondary Plate Heater
1. Disconnect power.
2. Pull heater out from under jiffy clips.
3. Position new heater under jiffy clips. Be sure
offset is properly positioned around the
drain. If jiffy clips are removed, make cer-
tain sealer is replaced.
4. Reconnect power.
5. Verify that heater is working correctly.
6-6 SERVICE
P/N 0387183_D WWW.HUSSMANN.COM
Always disconnect the electrical power at
the main disconnect when servicing or
replacing any electrical component. This
includes, but is not limited to, such items
as fans, heaters, thermostats and lights.
WARNING
!
Rear Secondary
Plate and Heater
Front
Secondary
Plate and
Heater
Interlock
Plates
Together
Strap together
and Attach to
Harness
Slide Rod Heater
Under Tabs.
Lightly Press
Down on Tabs.